PRESS    |   CONTACT

                                                                                                   Home        Generators        Solar          Wind       


Energy Reduction Products

Intellicon is a “smart”, inexpensive, micro-computer based energy saving device that can be easily installed on Residential and Commercial hydronic and steam heating systems, central air conditioning systems and commercial refrigeration units. In laboratory tests conducted by independent testing laboratories and in real world installations, IntelliCon® has delivered energy consumption savings of 10% to 30% or more without affecting the temperature levels.  

 

Compress Shield™ for Commercial Cooling and Heating Systems

Compress Shield™ guards against the costly loss of cooling capacity. Compress Shield™ and oil are 1500% stronger than the oil alone. With Compress Shield™, you’ll enjoy quieter operation, enhanced compressor seal protection, average energy savings of 14.8%! 

Independent research shows that lubricant build-up on your refrigeration system’s internal surfaces can degrade its performance by up to 30% preventing it from transferring heat, increasing pressure drops, elevating boiling points and reducing its latent heat capacity. 

Over time, this continuous loss of cooling capacity escalates your power bills, maintenance and capital costs as the system’s efficiency degrades. But Compress Shield™’s ability to accelerate the heat-transfer process through metallurgical thermodynamics and metal-surface chemistry helps you maintain the peak performance that’s key to minimizing your long-term operating costs. 

As soon as your refrigeration system is turned off or cycles off, oil drains from the compressor’s metal surfaces, breaking the boundary film -– the layer of oil between its moving parts. 

Thanks to Compress Shield™’s patented polar bond, the boundary film remains on the surface and protects the metal, even when the oil layer is not fully established. So when the layer reforms, the combination of Compress Shield™ and the oil is 1500% stronger than the oil alone. This reduces your system’s operating load by accelerating the heat transfer process, which cuts wear and tear while extending the life of your equipment. 

Once introduced, Compress Shield™ remains in a liquid state as it migrates throughout the system prior to separation from the carrier oil. Compress Shield™ molecules displace the insulative layer of nonconductive oil and permanently bond to all system surfaces. The result: significantly higher heat-transfer rates through electromagnetic heat propagation. 


Five ways that Compress Shield™ saves: 

1) Increases efficiency! This product either increases needed capacity or lowers energy use. If a system is sized and maintained properly, and is operating at its desired temperature goal, then the addition of Compress Shield® should cause the system to cycle off more and remain off longer (request Mobil-Exxon test and the Florida Field Tests). If the equipment will not maintain the required load, then the higher efficiency will help that (request FMC Test). 

2) Decreases amperage! Normally, there is an appreciable drop in amperage (request ECAPs Reports). However, at times it is minimal (FMC Test data). 

3) Lowers demand! In office buildings, schools, and homes, demand charges by utilities are set by the A/C and refrigeration equipment because it is the largest equipment on the premises. This can be very significant (request Benton Enterprises Data). 

4) Reduces maintenance costs! These costs are reduced through the added lubricity and protection afforded by the polarized molecule. During the off cycle, or if there is a loss of oil and/or oil pressure, or refrigerant flooding, the polarized molecule remains on the bearings, rods, pistons, etc. (request Bally’s Casino and Applied Process references). 

5) Increases the life of the equipment! This is achieved by reducing wear and heat in the system, particularly the compressor (request Rives & Reynolds and Quad City Controls Report). 

Energy savings in 1, 2, and 3 will pay for the application of the product in 12 to 18 months. In the long run, savings on maintenance and the increased life expectancy of equipment exceed the energy savings. 

View/Download Compress Shield Brochure

 

 

 

 

 

 

 

 

 

Intellicon  


Click here To view the Intellicon Product Line.

 

 

copyright 2003-2008 - EnCom Group. All rights reserved